ISO INTERNATIONAL STANDARD 9444-2 First edition 2009-06-01 Continuously hot-rolled stainless steel - Tolerances on dimensions and form Part 2: Wide strip and sheet/plate Acierinoxydablelaminé a chaud en continuTolérances sur les dimensions et la forme - Partie 2: Larges bandes et toles Reference number ISO 9444-2:2009(E) @ ISO 2009 IHSunder Not for Resale ISO 9444-2:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTED DOCUMENT @ ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ Iso 2009 - All rights reserved I without license from IHS Not for Resale ISO 9444-2:2009(E) Contents Page Foreword. 1 Scope 2 Normative references 3 Terms and definitions... 4 Information to be supplied by the purchaser 5 Type of delivery and delivery condition ..... 6 Tolerances on thickness for hot-rolled wide strip and sheet/plate. 7 Tolerances on width for hot-rolled wide strip and sheet/plate .... 8 Tolerances on length for sheet/plate... 9 Tolerances on edge camber for hot-rolled wide strip and sheet/plate 5 10 Tolerances on squareness for sheet/plate. 11 Tolerances on flatness for sheet/plate ... 12 Form of coils ... 13 Ordered format for sheet/plate..... 14 Measurement of thickness for hot-rolled wide strip and sheet/plate. 15 Measurement of width.. 16 Measurement of length... 17 Measurement of edge camber.. 6 18 Measurement of squareness 19 Measurement of flatness.. Bibliography.... ii from IHS Not for Resi