ISO INTERNATIONAL STANDARD 2538-2 First edition 2014-09-01 Geometrical product specifications (GPS) 一 Wedges - Part 2: Dimensioning and tolerancing Speécification géométrique des produits (GPS) - Coins - Partie 2: Cotation et tolérancement Reference number IS0 2538-2:2014(E) ISO @IS02014 No reproo Not for Resale IS0 2538-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved or networking permited without license from IHS Not for Resale IS0 2538-2:2014(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope.. 2 Normative references 3 Terms and definitions 4 Dimensioning of wedges. 4.1 Characteristics of wedges ..1 4.2 Dimensioning of wedges. 4.3 Standardized series of wedges. ..3 5 Tolerancing of wedges .4 Annex A (informative) Relation to the GPS matrix model .10 Bibliography ..12 Copyritnteatinal rganiason t? Sanadizal rights reserved ii se with ISt ed without license from IHS Not for Resale