ISO INTERNATIONAL STANDARD 527-3 Secondedition 2018-11 Plastics Determination of tensile properties - Part 3: Test conditions for films and sheets Plastiques - Détermination des propriétés en traction - Partie 3: Conditions d'essai pour films et feuilles Reference number IS0 527-3:2018(E) ee=Shenzhen Institute of Standards and Technology 9972181 @ IS0 2018 IS0 527-3:2018(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2018 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22 749 01 11 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland hicensee-Shenzhen Instte f Standards andeclSl0ge- All rights reserved ndards Bodies Not for Resale, 2019/7/29 02:08:51 or networking permitted without license from IH: IS0 527-3:2018(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Principle 5 Apparatus ..2 6 Test specimens. .2 6.1 Shape and dimensions. .2 6.2 Preparation of specimens .5 6.3 Gauge marks .5 6.4 Checking the specimens .5 6.5 Anisotropy ..5 7 Number of specimens .5 8 Conditioning ..5 9 Procedure. .5 10 Calculation and expression of results ..5 11 Precision ..5 12 Test report. ..6 Bibliography 7 Copyrintnteatonal OS&raizAl rights reserved ii icensee=Shenzhen Institute of Standards and Technology 9972181 Not for Resale, 2019/7/29 02:08:51